Twin Tech Tactical has designed, and is manufacturing a fully machined polymer takedown lever to replace the weak factory piece. This takedown lever is far superior to the Ruger injection molded part in two ways.
First our parts are fully machined from a billet block of a super strong, high impact resistant polymer. This process insures that there are no defects in the material, such as hotspots, porosity, or cooling cracks that are inherent on the Ruger injection molded piece. Second our parts have more impact surface area than the original Ruger factory piece.
Although our take down lever is superior to Ruger’s factory piece, it is not indestructible. There are a lot of different factors that will affect the life of our TDL that we have no control over, like: shooting suppressors wet with any ammo, hyper velocity ammo, improper installation, and homemade suppressors. We have made our best attempt to remedy a bad design and these parts should be considered a sacrificial piece that could fail at some point in the future.
Therefore no warranty is expressed or implied.
All prices are in USD